What are the reasons for the broken wire when the wire drawing machine is working?
The wire drawing machine is mainly used to draw the surface of the steel, so that the surface presents fine lines of equal thickness. In the process of using the wire drawing machine, sometimes the wire will be broken.
Reasons for wire breakage in wire drawing machine
1. In the continuous production of the wire drawing machine die, the sizing area of the wire drawing die will become larger due to normal wear and tear.
2. Because the annealing current is not constant during production, the current is suddenly high, and the single wire is pulled or fused by a sudden strong current during the annealing process.
3. Because of the quality problems of various rods. During the production process, the rods exhibit irregular quality defects, which cause the monofilament to be broken by various unpredictable tensions during wire drawing deformation. This situation rarely occurs when the rod is good.
www.chinawiredrawingmachine.com
