First of all, it is necessary to provide a good working environment for the inverted wire drawing machine. Do a good job of cleaning, so that the gear pump in the wire drawing machine can be kept in a dry environment without corrosive gas, so as to prevent the equipment and its parts from being adversely affected by external factors.
Secondly, if the inverted wire drawing machine has not been used for a long time, it is forbidden to measure the insulation resistance of the winding with a 500-volt megohmmeter as required before use. If the electric pump is used in a humid environment, it should be the same before use. If the measurement results show that the insulation resistance between the winding and the motor casing is lower than 7 megohms, it is necessary to take dry measures for the winding to prevent the working function of the gear pump in the wire drawing machine from being affected.
Then, since it is a high-speed operation device, it must be smooth. Before using the inverted wire drawing machine, be sure to check the gear pump, it is necessary to keep the smoothness at the bearing clean, and pay attention to replacement. Always check and repair, check whether each power cord, including internal wiring, plugs and switches are normal, whether there is any problem with insulation resistance, whether the brush tail seat is loose, whether the commutator and brush are in good contact, and whether the armature winding stage expansion stator winding is correct. Appropriate for circuit breakage, damage to bearings and rolling parts, etc.
Care should also be taken to save each component. When carrying out some disassembly and replacement operations, you should pay attention to check whether it can still be used normally, and make a record. When replacing parts, you must choose parts that conform to the standard, and all parts must be installed in accordance with the original ones. The orientation is installed, and no loss is allowed to ensure that the inverted wire drawing machine can work normally.
www.chinawiredrawingmachine.com
