After the wire drawing machine is equipped with a mold, the diameter of the aluminum wire should be reduced in accordance with the requirements of the mold, so that the wire diameter can be smoothly passed through the mold. After the wire diameter is passed through the film, the thread end is inserted into the wire drawing pliers, and the mold is pressed to the first one. In the mother seat of the No. 1 wire drawing machine , the other end of the wire drawing rope is hung on the small hole of the wire drawing pot, and the foot switch is activated to make the wire drawing pot move. After drawing several laps, remove the lead wire pliers, and then start the No. 1 machine, so that there are more than half of the semi-finished wire drawing on the No. 1 machine's wire drawing pan, and then introduce the aluminum thread end to the No. 2 machine through the hanging wire wheel and the wire passing wheel . Perform the second die shrinking and threading as required, and inching drawing, in this cycle, the drawn wire is drawn to the take-up wheel after passing through multiple dies, the take-up machine is started, and the drawing process is started. Turn the switch knob to the linkage start main unit switch knob and wire take-up button, adjust the variable frequency potentiometer speed control knob of each machine , and adjust the knob of the wire take-up torque motor controller at the same time, so that the motor speeds up at the same time, so that it runs normally and draws wires. Use speed regulation to achieve the best matching effect.
https://www.chinawiredrawingmachine.com/
