1. Turn on the power supply and start the AC main motor to make it run without load.
2. After the inverted wire drawing machine is working normally, no operation can be performed on the wire drawing machine.
3. Put the wire drawing die into the die box of the inverted wire drawing machine, and add wire drawing powder if necessary.
4. Slowly and uniformly start the main engine of the inverted wire drawing machine, and the speed rises steadily until the equipment starts to work normally.
5. Put the trolley and the wire drop frame of the inverted wire drawing machine in place, and put down the wire take-up support, so that the take-up tray is in the state of wire take-up, and the wire can be dropped smoothly.
6. First of all, carefully check whether the lubricating oil of each lubricating point is sufficient; check whether the air circuit is closed well and whether there is air leakage; check whether there is a drop frame on the trolley.
7. Loosen the wire drawing pliers, withdraw 2-3 circles of metal wire, manually control the air valve, make the wire crimping roller press the wire on the reel, and introduce the withdrawn metal wire into the drop frame.
8. After the wire take-up trolley is full, shut down the main engine, cut off the metal wire, pull out the trolley, lift out the metal plate with a crane, and then put it into the trolley, and repeat the above operations.
9. During the normal operation of the inverted wire drawing machine, it is necessary to frequently observe whether the equipment has abnormal sound or heat, and if so, stop it in time for inspection to avoid unnecessary losses or dangers.
10. Put the metal wire rolled by the tip mill into the mold, press it with wire drawing pliers, hang one end of the wire drawing pliers on the reel, and operate the speed control button to make the reel pull the wire at a slow speed for 10-20 Stop after lap.
www.chinawiredrawingmachine.com
