1. Check whether the lubrication level of each lubricating point of the stainless steel wire drawing machine is in place, whether the pressure of the water and gas lines is within the qualified range, and whether there is a falling wire rack on the trolley; pull all the wire racks and the trolley to the At the designated position, lower the claw and connect it to the claw.
2. Turn on the power supply and let the AC main motor run without load for a certain period of time; place the wire drawing die in the die box of the stainless steel wire drawing machine; thread the steel wire that has been nearly rolled into the die beforehand, or draw the wire. Put it in the pliers and press it tightly, and hang the other end of the wire drawing pliers directly above the reel. Turn on the speed control button to let the reel rotate slowly with the traction wire, about ten to twenty turns. about.
3. Remove the wire drawing pliers and withdraw the wire for two to three turns, manually control the air valve, let the wire pressing roller press the wire on the reel tightly, and then pull the previously withdrawn wire to the drop frame. ; Then start the host at a slower speed, and then gradually increase the speed, and then the device can enter the working state normally.
4. When the stainless steel wire drawing machine is working normally, no personnel can perform other work under the equipment. When the drop frame is full of wires, stop immediately, manually control the air valve to release the pressing roller, push the trolley out, and then lift all the wires on the drop frame out, and then remove the trolley Pushing in works again.
5. The stainless steel wire drawing machine needs cleaning and maintenance after use. Especially the stainless steel wire drawing machine with water mill, after use, it is necessary to clean the dust on it, and then use the air gun to dry the water stains to avoid rusting.
www.chinawiredrawingmachine.com
