The water in the water tank drawing machine can be used as drawing oil, and its specific function is to clean and cool. As for the problem of running number when drawing steel wire, the specific reason is that the drawing machine is poorly lubricated, which causes the wear of the mold, etc., and then this problem occurs. Therefore, in preventive measures, there must be good and adequate lubrication, and if there is sediment, it should be filtered out in time. In the water tank drawing machine, if this problem occurs and the water temperature is normal, then it may be that the amount of oil is too small. At this time, the oil should be checked and the amount should be added in time. If it is not the oil problem, then check the cooling system, water temperature sensor and water temperature control box and other electrical units to see if there are any problems, and if any, they should be repaired or replaced in time. If the wire drawn by the water tank drawing machine is very soft, but there is no problem with the material, then the specific reason may be insufficient cold work hardening during the drawing process. At this time, the problem can be solved by increasing the speed. As for the equipment that can be matched with the water tank drawing machine, there are plum blossom type drop-off machines and so on.
https://www.chinawiredrawingmachine.com/
