1. In the plastic flat wire drawing machine, the thickness of the extruded film is mainly adjusted by what?
In the plastic flat wire drawing machine, the thickness of the extruded film is mainly adjusted by the pulling speed or the screw speed. Therefore, once the thickness of the extruded film is uneven, then the main adjustment is to adjust the pulling speed, or It is the screw speed, thus, to solve the problem.
2. What is the difference between the wire drawing of the wire drawing machine and the straightening and cutting of the straightening and cutting machine? In addition, is the reason for the wrong position of the wire drawing machine different in different wire drawing machine types?
The wire drawing of the wire drawing machine and the straightening and cutting of the straightening and cutting machine are obviously different, because the wire drawing is to pull the material to the required diameter, and for the straightening and cutting, the disc is straightened and then cut. To the required length, therefore, this conclusion can be reached. As for question 2, it can be said that the answer is yes, different types of wire drawing machines have different specific reasons.
3. What are the specific types of wire drawing units? In addition, when the wire drawing machine is annealed, the material is broken. What is the reason?
There are two types of wire drawing units: ordinary wire drawing units and high-speed flat die wire drawing units, and it can be said that the grade of the former is lower than the latter. When the wire drawing machine is annealed, the problem of material wire breakage occurs. The root cause is that the material does not have toughness or its toughness is insufficient, which leads to the above-mentioned problems. Therefore, the toughness of the material should be improved to make it reach the standard, so that it can be solved very well.
https://www.chinawiredrawingmachine.com/
