Home > News > Content
The Wire Drawing Machine Is Precisely Controlled By The Speed
Sep 30, 2017

A mechanical device that can provide a very accurate and smooth linear speed is commendable, and the Wire Drawing Machine is one of such devices, the system for the speed control requirements are very high.

The whole system is more complex, the control equipment requires coordination between the various motors. The system uses four servo motor control, can fully meet the real-time interaction between the data. In order to ensure that the side of the track in accordance with the algorithm side of the line, requiring the line of the wire can be quickly calculated. Full use of the servo internal firmware function, calculated by the drive itself, greatly omit the traditional wire drawing machine control system line position to calculate the total time. And then send the instructions to the drive to ensure that the line line to minimize the delay through the controller.

Usually the Wire Drawing Machine is always used for long-term use of drawing template, because of its work when the mold wall will always be a different wire of the strong erosion and friction, usually cause some wear and tear, usually in the material entrance to the formation of a small dent The If there is a cable die ring groove, will accelerate the wear and tear of the template, if not timely repair, the loss will continue to increase, and then will greatly increase the difficulty of repair, serious words will make the ring groove deeper cracks, Completely broken broken scrap.

To avoid this situation, the operator must be based on the daily work of fine experience, for the wire drawing machine equipment, a set of routine maintenance of the standard standard. During the operation, once the template has a slight wear and tear, to be timely polishing, so that the template can be restored in a short period of time to the original polishing state, and its hole size will not have much change.


Products List