The installation of the wire drawing machine should be firm and stable, keeping a horizontal position. Stationary machinery should have a reliable foundation; outdoor operations should be equipped with a hangar, and a place where raw materials and semi-finished products should be stacked next to the machine. The equipment controlled by the counterweight should be matched with the pulley, and there should be signs indicating up and down. If there is no indicating sign, a special person should be instructed. The height of the counterweight frame should be limited to within the ground when the counterweight frame is lifted, and there should be railings and warning signs around the counterweight frame . Before processing, make sure that the lubrication system is unblocked, check the condition of the drawing oil, whether there is any foreign matter or impurities, etc. If there is a deterioration problem, it should be replaced in time. The operator must see the commander's signal and wait for all personnel to leave the danger zone before working. The cold drawing should be slow and even. When there is a stop signal or someone enters the danger zone, stop pulling immediately and relax the hoisting wire rope slightly. Devices that use elongation control should be equipped with obvious limit signs, and a special person should be responsible for command. After the operation, the finished products should be stacked, the site should be cleaned, the power supply should be cut off, the switch box should be locked , and the lubrication should be done.
https://www.chinawiredrawingmachine.com/
