How to solve the problem of nail caps produced by nail making machine?
1. No nail cap: This is a common fault. Most of the time, it is because the fixture cannot clamp the nail wire tightly. You only need to replace the fixture. Another possibility is that the nail wire reserved for punching the nail cap is too short. Adjust the length of the reserved nail wire. 2. The nail cap is not round: This fault is usually caused by the fixture. First, observe whether the countersunk hole on the fixture is round. If it is not round, it needs to be re-drilled. It is also necessary to observe whether the die hole of the fixture is uneven and adjust it to ensure flatness. Another possibility is the problem of the nail wire. Either the nail wire reserved for punching the nail cap is too short, adjust the length of the reserved nail wire; or the nail wire is too hard to punch out the nail cap or the nail cap is unqualified, and the nail wire needs to be annealed. 3. The thickness of the nail cap: It is also necessary to check the fixture to see whether the height of the two fixtures is the same, and whether the fixture can clamp the nail wire. In addition, observe whether the countersunk hole of the fixture is severely worn on one side. Finally, it is necessary to observe whether the nail wire is too hard to cause the punched nail cap to be unqualified. 4. The nail cap is skewed: First, check whether the center of the two nail cutters is consistent with the center of the nail mold, whether the front and back height of the nail cutters are neat, and also check whether the countersunk holes of the two nail molds are in the same plane. Finally, check whether the mold shell is loose.
https://www.chinawiredrawingmachine.com/
