What are the daily maintenance and care methods for the straightening and cutting machine?
cleaning job
After finishing work every day, clean the dust, oil and debris on the surface of the machine to keep the machine clean and tidy.
Clean out metal chips and debris in the straightening mechanism, traction device and cutting device to prevent them from affecting the normal operation of the machine.
Lubrication maintenance
Regularly add an appropriate amount of lubricating oil to each moving part of the machine, such as rollers, bearings, screws, etc., to reduce wear and friction.
Pay attention to using appropriate lubricating oil and lubricate at the prescribed intervals.
Check the parts
Before starting the machine every day, check the wear of the straightening wheel, pressure wheel, cutter and other parts. If there is severe wear, replace them in time.
Check the tightness of the belt and chain and the lubrication of the relative moving parts . If there are any problems, make adjustments in time.
Electrical system maintenance
Check the electrical circuits regularly for damage or aging, and ensure that the circuits are firmly connected.
Clean the dust inside the electrical control box to maintain good heat dissipation of electrical components.
Calibration and commissioning
Regularly calibrate the machine's straightening accuracy and cutting length to ensure they meet production requirements.
Check the coordination of traction speed and cutting frequency and make necessary adjustments.
Fastening screws
Regularly check whether the screws and nuts in various parts of the machine are loose and tighten them in time.
Storage Notes
If the machine is not used for a long time, it should be stored in a dry, well-ventilated place and take protective measures.
Safe operation: Operators should wear labor protection equipment, such as helmets and gloves, to avoid injuries due to careless operation. During operation, make sure that your hands are not close to dangerous parts such as knives to prevent accidents.
Special attention: During operation, you should frequently check whether the temperature and sound of each bearing and oil tank are normal. If you find that the temperature is too high or the sound is abnormal, you must stop the machine immediately for inspection and maintenance .
Through the above maintenance and care measures, the service life of the equipment can be effectively extended, the equipment failure rate can be reduced , the safe operation of the equipment can be ensured , and the work efficiency can be improved .
Maintaining and servicing the straightening and cutting machine well can make your production more efficient. Wandeshun 's straightening and cutting machine , with its excellent quality and perfect maintenance system, will become your right-hand man on the road to success.
https://www.chinawiredrawingmachine.com/
