Introduction to the operating procedures of the rough drawing process of the inverted wire drawing machine
For the equipment of the inverted wire drawing machine, in the actual operation of rough drawing, the key technical specifications that everyone must abide by can be summarized into six levels. That is, in all the links of use, the hot-rolled strip grooves should be rolled in order from large to small to prevent the sticking of the tipping machine. In addition, the tie should be symmetrical to prevent the stainless steel wire from tying the flat belt with burrs.
In the case of mold matching, it must be selected according to actual needs, and the actual effect of metal drawing of the inverted wire drawing machine equipment. Remember, when punching, check the gaskets. If the tightness is not good, it can cause many problems.
The workers should adjust the position of each mold box. When the stainless steel wire exits the mold hole, it should enter the wire rope reel horizontally from the tangential direction to prevent problems such as cracks in the middle pass.
The staff must also fill in the detailed operation records carefully. Remember, the specifications and models of the products, the production date and the operator number must be clearly filled in; the fifth point is that the inverted wire drawing machine is in the production process. The lubricating fluid in the mold box should be fresh, and it should be mixed diligently, and the coke and dirt in the mold box should be removed immediately to prevent problems.
www.chinawiredrawingmachine.com
