What are the applications of straightening and cutting machines ?
Straightening and cutting machine is a machine used to straighten and cut steel bars with a diameter of less than 14 mm. The cutting length can be customized according to customer requirements. Straightening and cutting machine is widely used in stainless steel wire, cold drawn wire, galvanized wire, iron wire, steel wire, aluminum wire, water-drawn wire, steel bar, etc. Straightening and cutting machine has the characteristics of fast speed, small error, no wire running, reasonable structure, convenient operation, safety and reliability, etc. It can be widely used in various fields of hardware products, handicrafts, and daily necessities production. Such as: pet cages, chicken cages, air conditioning mesh covers, bicycle baskets, spokes, umbrella racks, bird cages, refrigerator shelves, wire baskets, construction wire, wire mesh screens and other metal wire straightening and cutting. One of the steel bar processing machines, used to straighten and cut steel bars with a diameter of less than 14 mm and remove rust. It consists of a straightening cylinder, a traction mechanism, a cutting mechanism, a steel bar fixed length rack, a rack and a drive device. Its working principle is that the motor increases the speed through the belt drive, so that the straightening cylinder rotates at high speed, the steel bars passing through the straightening cylinder are straightened, and the rust on the surface of the steel bars is removed by the straightening die; the motor drives two conveying rollers through another pair of speed reduction belts and gear reducer, on the one hand, to pull the steel bars forward, and on the other hand, drives the crank wheel to make the hammer head move up and down. When the steel bar is adjusted to the predetermined length, the hammer head hits the upper knife holder to cut the steel bar. When the cut steel bar falls into the receiving rack, the knife table returns to its original position due to the spring action, completing a cycle. Cutting machine operation procedures Steel bar straightening machine 1. Carefully implement the relevant provisions of the "General Operation Procedures for Forging Equipment". 2. Carefully implement the following supplementary regulations: Carefully do the following during work: 1. When the head of the steel is bent and cannot be fed in, the machine should be stopped and taken out immediately, and it should not be allowed to pass. 2. When it is found that the steel is fed in in a screw shape, it should be stopped and taken out immediately, and it should not be allowed to pass. 3. If the straightened steel is a coil, you should always pay attention to the working condition of the coil rack, and stop the machine immediately if you find any confusion. When the coil processing is almost finished, the tail of the material should be removed from the coil rack. 4. Remember to turn off the switch and cut off the power supply after the work is finished.
https://www.chinawiredrawingmachine.com/
